Recent content by Kingpin

I dont know but I can give measurements if anyone needs them. Its been sitting upright in my glass case for about 2 years so I cant remember what I purchased. It doesnt state what it is on the tube.

I think it's new. I haven't played for a couple years because of health issues. Text me and I will check on it. 320-295-8342

Sorry guys. It's about 6 ft long with a countertop underneath. So I can't ship it. I'm in MN so I could meet someone around 100 miles out but that's the best I could do. I'm in the twin cities. Thank you

Hey guys, I have had this lathe for a few years and havent gotten much use out of it. I dont even remember the brand or model. I have lots of Tips, Some predator, some Le Pro, and I think some samsara break tips etc. I have a bunch of tooling, rings, reamers, threads for making joint...

Long gone.

Cue is sold. Sorry about the screw up on my end. I sent the correct Email address. G

I had Scott turn down the butt and shaft and I was going to finish it. I never got a round to doing it. At the same time I lost the bumper on the bottom. Im sure anyone who repairs cues would have something that would work. Im asking 200 for the cue and 15.00 fpr shipping. Any interest, let...

30.25.

I have had the shaft for a year or so and just need to get rid of it. Its new, It needs to be cut and threaded. 12mm. Asking 130.00 shipped to your door, or make an offer. Reasonable offer, Thanks

Great looking wood. Will need to be stabelized. Asking 50.00 per 3"x4"x 30"sections some slightly shorter but most in that area. Any questions, feel free to give me a shout.

I have a bunch of leftover Spalted Maple that I wont be using. Most of it is a bit spunky so more than likely it will need to be stabilized. The sizes are 3"x4"x 30". Some shorter some longer. Im asking 50.00 a piece but if you buy more they will get to be quite cheap. I need to get rid of...

Damn nice looking cue!

Messsage sent

Hlad, How much do you want for your piece?

I just did a set and Im asking 50.00 for them. Its for one shaft and one cue. Any questions, feel free to PM me. .850 around and a radial pin. Thanks, G