Predator 314 shaft (1st gen.) - 5/16x18

O

obr

AzB Silver Member
Silver Member
Purchased from KOINNKID ~ 4months ago...found out that LD shafts are just not for me :(
http://forums.azbilliards.com/showthread.php?t=149134

Taken from thread:
3.5 oz..
12.62 mm Wizard medium tip.
29 inch.
5/16-18 thread flat faced joint.
Straight.

imgp2732.jpg

imgp2733.jpg

imgp2734.jpg

imgp2735.jpg

imgp2736.jpg


Asking $OLD
 
Last edited:
Nice Price.....

What's the measurement of the joint? Do you have a little better pic of the ringwork (silver ring) size?? Good luck with your sale :smile:
 
Isn't this shaft considered 2nd generation? The first gen. predator shafts only read 314 with no cat logo.
 
krbsailing said:
What's the measurement of the joint? Do you have a little better pic of the ringwork (silver ring) size?? Good luck with your sale :smile:
Click to expand...

hi, i'll try to get a measurement of the joint tomorrow. i dont own a caliper, but i'll try to be as accurate as possible w/ a ruler. i apologize for the quality of the pics, i will try to retake some tomorrow too. thx :)

Deadon said:
A price please.
Click to expand...

price is at the bottom, $120 obo

runout1961 said:
Isn't this shaft considered 2nd generation? The first gen. predator shafts only read 314 with no cat logo.
Click to expand...

i'm really not too familiar with the predator history, i was under the assumption that the 314^2 shafts were second generation.
 
runout1961 said:
Isn't this shaft considered 2nd generation? The first gen. predator shafts only read 314 with no cat logo.
Click to expand...

The statement in the quote is incorrect.:eek:
This is a Gen-1 shaft. There is no difference btwn. Cat & No Cat other than the decal. It's the same shaft. They are both Gen-1.

Gen-2 shafts have the obvious (2) included in the decal unless the decal has been modified.

The silver ring is .030". If this is a factory built shaft (which I believe it is), the joint dia. is .830".
 
KJ Cues said:
The statement in the quote is incorrect.:eek:
This is a Gen-1 shaft. There is no difference btwn. Cat & No Cat other than the decal. It's the same shaft. They are both Gen-1.

Gen-2 shafts have the obvious (2) included in the decal unless the decal has been modified.

The silver ring is .030". If this is a factory built shaft (which I believe it is), the joint dia. is .830".
Click to expand...
Good to know.....
 
You must log in or register to reply here.
Back
Top