I have a couple customers with revo shafts wanting new tips, any advice would be appreciated from those that have done it. I know the red pad on them is a big deal to watch out to not mess with.
NOTE: I have a porper lathe and have been doing tip and shaft work (on the side) for 15 years so I am not an amateur just like many of us I am assuming, I have not dealt with revos yet. Also if anyone wants to PM me instead of talking public that's fine too.
Thanks in advance
NOTE: I have a porper lathe and have been doing tip and shaft work (on the side) for 15 years so I am not an amateur just like many of us I am assuming, I have not dealt with revos yet. Also if anyone wants to PM me instead of talking public that's fine too.
Thanks in advance