Tiger Everest question

td1223 · Feb 19, 2018

A friend just brought over a Tiger Everest to install on his shaft. On the bottom where you apply the glue I notice a red layer. My question is, do you sand this layer off or just ruff it up as normal? I knew they had the red layer to tell you when to change the tip but was not aware of the bottom being red as well.

Thanks,

M.G. · Feb 19, 2018

The answer to all Tiger Everest questions is: DONT USE IT IT'S DAMN NEAR CRAP.
Use Sniper, Onyx, Tiger soft. But not the Everest.

PS: As for the layer, just rough it up, glue as normal.

CrownCityCorey · Jun 21, 2018

td1223 said:
A friend just brought over a Tiger Everest to install on his shaft. On the bottom where you apply the glue I notice a red layer. My question is, do you sand this layer off or just ruff it up as normal? I knew they had the red layer to tell you when to change the tip but was not aware of the bottom being red as well.

Thanks,

Just scuff it as normal. It's a fiber pad that cuts/trims just fine with a sharp blade on your lathe.

Tiger Everest question

td1223

AzB Silver Member

M.G.

AzB Silver Member

CrownCityCorey

Sock it to 'em!