So somewhat of a "bastard" pin KJ? I think Joey was saying drill the hole deeper not bigger? Correct me if I'm wrong. So bottom line, is there anything I can do to get an aftermarket Radial shaft to fit this JW?
In this particular example no, it's not a bastard, at least in my opinion.
This pin is pertinent to this cue. That's the pin it was meant to have
and for no amount of love or money would I consider changing it.
Also in my opinion, no one should be allowed to work on that cue other than
Bill himself or his appointee. That's how 'special' I believe this cue to be.
One of his prototype cues built during his R/D of the Radial !!!
ARE YOU KIDDING ME ???
As to an aftermarket shaft, the pin in the JW does not present a problem.
As to make & mdl of said shaft; well, that's up to you and possibly the builder.
KJ