DO NOT PM ME!!!! FIRST POST I'LL TAKE IT GET IT.
Here are few shafts been tapered and sitting around for a while in my shop. I was going to use it for jump cues shafts. But I change my mind. These are straight grain. Just check last night on my taper lathe between center they are straight. These are not high end cue shafts. They are all 30 inches. Spec. will show as follow by number on pictures.
p.s. couple have 6 and 7 ring count , the rest of them have 9 to 10 ring count.
$OLD!!!
1) 3.7 oz. tip end .5625, joint end .8875
2) 3.7 oz. tip end .5655, joint end .8875
3) 3.6 oz. tip end .5585. joint end .8415
4) 4.3 oz. tip end .5860, joint end .9200
5) 4.0 oz. tip end .5880, joint end .9130
6) 4.0 oz. tip end .5875, joint end .9200
7) 4.1 oz. tip end .5850, joint end .9200
8) 4.2 oz. tip end .5855, joint end .9200
Here are few shafts been tapered and sitting around for a while in my shop. I was going to use it for jump cues shafts. But I change my mind. These are straight grain. Just check last night on my taper lathe between center they are straight. These are not high end cue shafts. They are all 30 inches. Spec. will show as follow by number on pictures.
p.s. couple have 6 and 7 ring count , the rest of them have 9 to 10 ring count.
$OLD!!!
1) 3.7 oz. tip end .5625, joint end .8875
2) 3.7 oz. tip end .5655, joint end .8875
3) 3.6 oz. tip end .5585. joint end .8415
4) 4.3 oz. tip end .5860, joint end .9200
5) 4.0 oz. tip end .5880, joint end .9130
6) 4.0 oz. tip end .5875, joint end .9200
7) 4.1 oz. tip end .5850, joint end .9200
8) 4.2 oz. tip end .5855, joint end .9200
Last edited: