Anybody know what the standard is for the original UniLoc pin diameter? And what the acceptable tolerances are? I ordered some components and one of the stainless pins is larger than the rest and it bound and galled up one of the brass inserts after I test fit it by hand. I had to whack it out with a little drift.
The offending pin mic'd at .2790 while the rest measured .2786 or .2787. For reference, my Lucasi and Predator cues measure .2785 and .2787 respectively.
I can't reliably measure the bore of the inserts I received, or the inserts in my shafts, but aside from the one ruined on the big pin they all have a nice slip fit on the normally sized pins.
I'll reach out to the company to get these items replaced, but I'm curious what the spec is on these things, and how 4 tenths caused me such a headache.
Thanks.
The offending pin mic'd at .2790 while the rest measured .2786 or .2787. For reference, my Lucasi and Predator cues measure .2785 and .2787 respectively.
I can't reliably measure the bore of the inserts I received, or the inserts in my shafts, but aside from the one ruined on the big pin they all have a nice slip fit on the normally sized pins.
I'll reach out to the company to get these items replaced, but I'm curious what the spec is on these things, and how 4 tenths caused me such a headache.
Thanks.