Cue tip replacement

Rogue8ball · Oct 16, 2017

Hi, I would like to learn tip replacement. I've seen kits and such but figured I'd have some better luck here asking on here. I'm looking at purchasing a small lathe for repair and have some one piece cues I can attempt on. Thank you, and look forward to hearing from everyone.

-Rogue

Kimmo H. · Oct 16, 2017

Here is an old reply of mine from another tip installation thread with a description of the basic process that I use personally.
http://forums.azbilliards.com/showpost.php?p=5838575&postcount=8

Tip work is relatively easy when you have the right tools and glue along with some patience. Just be careful that both the tip and the ferrule are flat prior to installing a new tip on and be careful not to cut in to the ferrule while trimming down the tip

Have fun learning :smile:

Rogue8ball · Oct 17, 2017

Kimmo H. said:
Here is an old reply of mine from another tip installation thread with a description of the basic process that I use personally.
http://forums.azbilliards.com/showpost.php?p=5838575&postcount=8

Tip work is relatively easy when you have the right tools and glue along with some patience. Just be careful that both the tip and the ferrule are flat prior to installing a new tip on and be careful not to cut in to the ferrule while trimming down the tip

Have fun learning

Thank you! Appreciate the response and information.

Rogue

Cue tip replacement

Rogue8ball

Registered

Kimmo H.

AzB Silver Member

Rogue8ball

Registered