I ended up with this carolina cue a while back off of ebay, price was right for what it is. Got looking at it again today and the issues and was wondering what some of the cue makers here think on trying to get the cue back to its glory.
Issue #1: I assume a ding that somone decided was a good idea to go to town with sand paper right below the joint.
Issue#2: i assume the same issue as #1 but they tried to refinish and it turned out horrible.
I was thinking perhaps the butt could be turned down, joint and all to get a nice constant taper again, possibly a differert piece after the wrap to fix issue 2?
Anyone here want to tackle this, i know this is going to be a bit of work with having to refinish, and new wrap on top of it all. How much would something like this cost?
Issue #1: I assume a ding that somone decided was a good idea to go to town with sand paper right below the joint.
Issue#2: i assume the same issue as #1 but they tried to refinish and it turned out horrible.
I was thinking perhaps the butt could be turned down, joint and all to get a nice constant taper again, possibly a differert piece after the wrap to fix issue 2?
Anyone here want to tackle this, i know this is going to be a bit of work with having to refinish, and new wrap on top of it all. How much would something like this cost?
Last edited: