Full Splice Six Points Dragon Cue

DBK

DBK

AzB Silver Member
Silver Member
Full Splice Six Points Dragon Carved Mammoth sleeved cue

Hi. Excuse for long absence.

Had a lot of work with Russian cues. And all time for pool cues was occupied with these cue. Recently has finished it for one of AZ-s. It has already arrived and I hope it has liked. It is full splice six points three recut. Two shafts hornbeam, black hornbeam six points crown. LBM short ferruls, Moory-M tips. The butt black hornbeam, hornbeam, Honduras rosewood. Black linen joint. G10 pin Radial type.

127612879.jpg


127612886.jpg


127612892.jpg


Set of protectors with coins.

127612921.jpg


To be continue...
 
Last edited:
I continue

The mammoth sleeve with carved Chinese dragon.

127612934.jpg


127613389.jpg


Here the sleeve before installation, the picture is better.

127612910.jpg


127612914.jpg


127612918.jpg


127612904.jpg


This picture which we have taken as the sketch of the dragon.

127612962.jpg


Work with this cue has given me huge pleasure :). I hope you liked the cue too.:)
Thanks.
 
Last edited:
Dragon Sleeved Cue

My cue came out excellent and well exceeded my expectations.

Dmitry took the example photo of the dragon I found and ran with it.
The detail in the mammoth sleeve carving is amazing.

The sleeve, however, was not to be out done by the quality of the even-length points in the butt of the cue and each of two (2) shafts.

The joint is simple to have the black flow from the forearm thru to the points in each shaft.

This is my first cue with the lighter weight G-10 pin. The cue hits great and has the feel of a one-piece cue.

I suggest you consider jumping on the current DBK raffle cue on the forum, buying a cue directly from Dmitry, or one of his that come up for sale on this forum.
 
Shafts

I turned a couple of Dmitrys shafts down to a simi pro taper, and they hit stiff but a lot like a good hard maple. I left some meat in them so when the buyer does buy them there is something to work with . Love these shafts , they are as good as our maple . Thanks Jim
 
Thanks, guys. Certainly the carved sleeve is not my work. It was made by the professional carver-artist. He made it 3 weeks. If I would make it, probably would make till now :). Difficult work.

Separate thanks to Robert for trust and patience.
 
You must log in or register to reply here.
Back
Top