Two very nice cues for sale. One is a 5 point Darrin Hill. Made of highly figured bacote. This cue was made in '05, and is signed on the bottom of the butt. 3/8x10 pin. 2 shafts. One is 12.7mm, and the other is 12.3mm. Cue wieghs 18.4oz and 18.2oz. One of the shafts has a sugar mark underneath the ferrule. Overall, this cue is in good condition. Very few blemishes for a used cue. I did notice a small amount of light underneath the joint when rolling, but nothing that should affect playability. Shafts roll good-maybe a small taper roll. I just do not use this cue much, so I would rather someone else get more use out of it.
Looking for $500 shipped in conus!
The other cue is a very nice Pechauer. I believe that this is model PL01, although I was told it may have been a custom order. Four floating points with MOP diamonds in each. Four rectangle inlays with MOP on the buttsleeve. Very nice ringwork also-looks like cocobolo under the rings. Weighs 19oz. Shaft is around 13-13.1mm. Cue rolls good-just a small taper roll in the shaft. Does not affect playability at all. A couple dings/chips in the buttsleeve, but cue is in overall good condition. The retail is $920.
Looking for SOLD shipped in conus!
Not really looking for trades at this time! Thanks!
Looking for $500 shipped in conus!
The other cue is a very nice Pechauer. I believe that this is model PL01, although I was told it may have been a custom order. Four floating points with MOP diamonds in each. Four rectangle inlays with MOP on the buttsleeve. Very nice ringwork also-looks like cocobolo under the rings. Weighs 19oz. Shaft is around 13-13.1mm. Cue rolls good-just a small taper roll in the shaft. Does not affect playability at all. A couple dings/chips in the buttsleeve, but cue is in overall good condition. The retail is $920.
Looking for SOLD shipped in conus!
Not really looking for trades at this time! Thanks!
Last edited:
