3/8x10 ACME drive arbor/pin set

Dave38

Dave38

theemperorhasnoclotheson
Silver Member
I was asked a bit ago to make one of these, and decided to make a couple few extras with an actual pin also, in case anyone else would have interst. These are for ACME threads like what Kikel uses, with the square threads. They will work for regular 3/8x10 also. Includes a delrin threaded cylinder and a 1.9" length of 3/8x10 ACME threaded rod to use when attaching to a shaft. The cylinder is .700" outside dia. If a dfferent size is needed, just let me know.
$15 shipped to 48 states, sorry, no international. Please respond here, pm's for questions, Thanks,
Dave

Picture 006.jpg

Picture 007.jpg
 
All pm's replied to. I still have about 7 sets left.
Thanks,
Dave
 
I will take a set and if u have just some pins for sale and a tap for these let me know also I am interested
 
I will take a set if you have any remaining please send me your PayPal address and i will send the funds
Thanks
Brett
 
I have one set left. If there is interest for more, I will order more materials to make them. Just post here if interested. I have been asked about selling the joint pins, and if enough interest, I will. I do not have the taps for sale. Those are very tough to find.
Thanks everyone.
Dave
 
All sets have been sold/spoken for. If anyone wants one, please respond here and if enough interest, I'll order stuff and build more. Thanks to all that have purchased these.
Dave
 
You must log in or register to reply here.
Back
Top