Low deflection shaft tapers: inch-by-inch measurements

N

NervousNovice

AzB Silver Member
Silver Member
Took some time to measure the inch-by-inch taper diameters of some low deflection shafts. Enjoy!

Edit: All shafts are 29" long, factory default, unaltered. Horizontal axis is length from top of ferrule (in inches). By the way, the horizontal axis starts from 1 to 30 but it should mean 0" to 29". Vertical axis is shaft diameter (in mm).

View attachment 388760
 
Last edited:
Holy smokes that was a lot of effort! Thanks so much for doing that!

Are all these 100% stock without any alterations? If so, it's a great way for people to get a visual comparison to the tapers! Awesome!
 
Nervous, you have failed to define the parameters of your graph. Just looking at it I might think it's the ratio of peperoni to square inchs of pizza, for a 12" medium.
Your work is good, but just incomplete. :)
 
You must log in or register to reply here.
Back
Top