I just received my new Mezz WX900. I ordered it in 3/8x10 not knowing that it would not fit the modified (flatbottom) 3/8x10 pin on my cue. I've never had this problem before. Apparently most manufacturers bore their shafts large enough to fit both, but Mezz does not. The standard 3/8x10 has a minor diameter of .302", which is what Mezz has bored, but the modified pin has a minor diameter of .308".
I've done some research, and it appears that the shaft can be bored to a .3125" diameter and it will be able to fit my pin without being too sloppy, as this is what OB, Tiger, and other aftermarket shaft manufacturers bore their shafts to. My question is, a standard 5/16 drill bit has a diameter of .3125". Would I be able to use the standard bit and do it myself? I do have access to a basic cue repair lathe mainly used for tip installs.
Thank you for your help.
I've done some research, and it appears that the shaft can be bored to a .3125" diameter and it will be able to fit my pin without being too sloppy, as this is what OB, Tiger, and other aftermarket shaft manufacturers bore their shafts to. My question is, a standard 5/16 drill bit has a diameter of .3125". Would I be able to use the standard bit and do it myself? I do have access to a basic cue repair lathe mainly used for tip installs.
Thank you for your help.