PDA

View Full Version : Looking for bumpers


rebop
06-20-2010, 01:31 PM
Looked everywhere I can find online and no luck.

Looking for those very flat bumpers called "mushroom bumpers" to pressure fit in a 5/8th hole in the butt of my cue. Cannot find any.

Any pointers?

Thanks.

~Bob

oldzilla
06-20-2010, 02:11 PM
check this out

http://www.azbmarketplace.com/catalog/LimbSaver-309-1.html

oldzilla
06-20-2010, 02:14 PM
or this maybe

http://www.cuecomponents.com/rubuinst.html

Eric Wynne
06-20-2010, 02:15 PM
Prathers , Atlas , Cue Components , Ebay ....:cool:

rebop
06-20-2010, 02:16 PM
Thanks, but not at all what I am looking for.

Think those slim bumpers like on a Scruggs, but his screw in with a rubber screw thread on the bumper. I need slim like that, but 5/8 ths and push in - no screw either in the rubber or through the rubber.

~Bob

LAlouie
06-20-2010, 02:19 PM
Thanks, but not at all what I am looking for.

Think those slim bumpers like on a Scruggs, but his screw in with a rubber screw thread on the bumper. I need slim like that, but 5/8 ths and push in - no screw either in the rubber or through the rubber.

~Bob

Scruggs is a cool guy. Ask him if he could sell a couple to you. Cogniscenti has those bumpers too.

rebop
06-20-2010, 02:21 PM
Oops, that was to the AZ Billiards link.

Watching Ebay, Cue Components not it. Nor Atlas. Looking at Prather now.

~Bob


Ps. Scruggs is similar, but would not fit. His have a smaller core and screw threads in the rubber.

rebop
06-20-2010, 02:26 PM
Only Prather that might work is out of stock :)

Cog's are a little thicker and more round.

rebop
06-20-2010, 03:15 PM
Here's a link to generally what I am looking for. Does not have to be exact, but similar.

And thanks for all the leads so far.

Http://www.billiardcue.com/image.popup.php?section=1&image=1&ID=429

Scott Lee
06-20-2010, 05:21 PM
Samsara cues also have the same kind of 'push in' bumpers you're talking about. I was missing one, and found it in another cuemaker's stock. The 'plug' was too big a diameter to fit the hole on my Samsara, so he turned it down on his lathe, until it fit perfectly. Likely you can do the same thing.

Scott Lee
www.poolknowledge.com

Only Prather that might work is out of stock :)

Cog's are a little thicker and more round.