Go Back   AzBilliards.com > Blogs > Snooker Theory
Reload this Page Very cheap homemade lathe
Rate this Entry

Very cheap homemade lathe

Posted 03-28-2020 at 10:36 PM by Snooker Theory

Quote:
Originally Posted by RussPrince View Post
I'm rather proud of this as I think it came out really well. It's a shaft lathe that cost me under $100 in parts total, $50 of which was for some custom delrin collets.

I bought an $18 drill from harbor freight and removed the handle. Cutting the handle off parallel with the drill body allowed it to sit on the bench flat and level.


Next, I made a collar out of 1/2 inch plywood that fits just around the neck of the drill.



For a steady rest I made a similar piece to the drill mount and inserted a sealed bearing with a 5/8 ID.


Here are the collets I purchased from cachin33 on ebay. He custom made them for me all with a 5/8 outer diameter to work with my 5/8 inch inner diameter bearing. $50


Here's shots of the tip being held in place. One side more for working on the shaft, the other for tip work.



The butt end of the shaft is held by a universal grip. It's made out of a replacement rubber made for the bottom of canes. $5


This is the variable speed controller from Harbor Freight. These cost $20. Works perfect for brushed tools like this drill. I modified it slightly to disable the "full speed" setting on the switch. I don't want to hit that on accident...


Here's a final shot of the whole thing. It's very steady. For fun I even turned down an old shaft I had about a mill to see if I could. It came out perfect. And now I can finally do my own tips correctly! Good stuff.
......mmm.....
Posted in Uncategorized
Views 271 Comments 0 Edit Tags
« Prev     Main     Next »
Total Comments 0

Comments

 


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity (Lite) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.