Go Back   AzBilliards.com > cbi1000
Reload this Page Conversation Between cbi1000 and BLACKHEARTCUES
Conversation Between cbi1000 and BLACKHEARTCUES
Showing Visitor Messages 1 to 1 of 1
    01-15-2010 02:58 PM
    I learned a long time ago to put a piece of electrical tape around the cue, above & below, the wrap groove. This will keep the press from running up onto the clearcoat. I use an old signpainter's trick. I cut 2 pieces about 4" long & stick it to my pants leg, a few times. That picks up some of the lint & dust from your pants. It still sticks, but it won't be so sticky as to lift the clearcoat. Always remove the tape pulling towards the wrap. By the way, for 24 years all I have ever used to press my wraps are 2 shafts. One on either side of the wrap. The ends are held in my left hand & I sqweeze with my right hand, on the other end...JER

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.