Recent content by sac14214

  1. sac14214

    Az Members who build their own cues please post photo's of your new and old work!!!!

    Shaft from post #351 in this thread: 30" long .860 joint 12.73 mm tip 3.7 oz.
  2. sac14214

    Az Members who build their own cues please post photo's of your new and old work!!!!

    Butt: 14.8 oz [ 29" - .844 joint, 1.291 butt ] Shaft: 3.4 oz [ 29" - .844 joint, 13mm tip ] Weight bolt: 0.7 oz Total: 18.9 oz Balance point: 17.75" measured up from butt Maple forearm is solid, attached to Honduran Rosewood at A joint. Maple for butt is sleeved over the HR. Plays really nice...
  3. sac14214

    Az Members who build their own cues please post photo's of your new and old work!!!!

    Curly Purple Heart and a piece of Curly Maple from an old pallet.
  4. sac14214

    Scallop secrets

    another attempt... butt section was short so mounted to a sacrificial dowel. Oversize, the flats cut round in later turning to size.
  5. sac14214

    Scallop secrets

    I played around with offsetting tail stock. Swapped out the wing cutter in router with a straight bit.
  6. sac14214

    Az Members who build their own cues please post photo's of your new and old work!!!!

    Asian Satinwood, Buckeye Burl with roasted Curly Maple Shaft
  7. sac14214

    Az Members who build their own cues please post photo's of your new and old work!!!!

    Birdseye and Maple Burl Just a reject that was hanging around in garage and a friend wanted to finish it.
  8. sac14214

    2 cues I am kind of proud of

    Just messing around out in the garage, doing this for fun.
Top