Search results

Put me on the list! Alan

Nope, I wasn't referring to you as a stoner at all. Just a reference to my original posting on this thread being a month before 4/20. I guess comedy is not for me. I'll see myself to the door. Alan

And a month too soon to be stoned.

It was actually a joke. The shaft is 3.8 oz. and the quarter makes it 4.0. The shown for size was the joke. Alan

PM me.

Induction heater on brass?

Yes, it will break.

Quarter shown for size

Still nothing from the seller. 550 bucks for nothing.

I've received no communication, tips or refund on the tip money I sent. That was 550 bucks.

.050 is quite a bit. You could always cut it with the tailstock recentered to closer to .800. Cut to around .805 and sand to match. Alan

No communications, no tips. Pretty easy to figure at this point.

Paid, awaiting tracking.

Check your PM's. I'll take them.

PM sent

Where are you located? I might be able to help with your shafts. Alan Phelps Custom Cues

I use 150 grit on a granite base plate.

Slower feeds are not always better. I get harmonic vibrations when my feed it too slow. All that depends on the cutter you are using. Try speeding up your feed rate on one of your junk shafts and see if it helps. Alan

I like my Rigids. I've been replacing my Porter Cables with them as the Porter's meet their eventual end. Alan

I think it is already copyrighted.