Search results

  1. T

    tubes for cases

    Hello. I was wondering what kind of tubing you guys use for making cases and where do you get them?
  2. T

    Dymondwood shafts

    Any interest in some dymondwood shafts? Rosewood color and around 32" long. Roughly .78" at ferrule end and dipped in stabilizer. I have 5. PM offer for trades or cash.
  3. T

    dying blanks

    Hello. Has anyone ever tried dying blanks while stabilizing them at the same time? I tried dying some maple burl using blue mixed in with my stabilizing resin but it doesn't look like its going to turn out right. I have a very good vacuum setup and used more powder dye than was recommended...
  4. T

    BIrdseye ash

    Has anyone seen or worked with birdseye ash before? I came across some and was just curious.
  5. T

    Lakeland shaft

    Hello. Has anyone ever hear of a lakeland shaft? This is what I was told the shaft is but there are not any identifying markings on it. It has a pear colored segmented ring and an old school micarta ferule. Thanks.
  6. T

    cuemakers guide to bobcad

    Has anyone tried the cue maker's guide to bobcad from Howard Smith? Thoughts and comments appreciated.
  7. T

    Lanoo lathe CNC conversion

    Hello. I recently purchased two Lanoo lathes and I am wanting to convert one with stepper motors into a cnc setup. What motors, drivers, and software does anyone recommend?
  8. T

    DIY veneers

    Hello. I was wondering if anybody dyes their own veneers? I recently purchased a vacuum chamber setup and tried dying maple and poplar veneers but the dye did not penetrate completely. I left them in for over an hour. I am using Transtint dye btw. Any help would be appreciated.
  9. T

    DIY veneers

    Hello. I was wondering if anybody dyes their own veneers? I recently purchased a vacuum chamber setup and tried dying maple and poplar veneers but the dye did not penetrate completely. I left them in for over an hour. I am using Transtint dye btw. Any help would be appreciated.
  10. T

    Full splice fixture

    Does anyone make and sell a fixture/jig to make full splice cuts? If no one does, what is the cut angle? Thanks.
  11. T

    Leather wraps

    Does anyone on here sell/produce leather embossed wraps at a wholesale level? Also, does anyone make their own? I figure it can't be that difficult. Thanks.
  12. T

    Tap and Die sets

    Does anyone know of a supplier/manufacturer that makes taps and dies both for 3/8-10 and UniLoc Radial pins? I'm looking to thread my own phenolic rods. Thanks.
Top