View Single Post
Started as an "All Paul", became "ABS", now it just "ARIZONA"
Old
 
CocoboloCowboy
Cowboys are my heros.
CocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond reputeCocoboloCowboy has a reputation beyond repute
 
Status: Offline
Posts: 26,922
vCash: 1538
iTrader: 91 / 100%
Join Date: Jul 2007
   
Started as an "All Paul", became "ABS", now it just "ARIZONA" - 12-18-2011, 07:24 AM

My NEW JB Cases arrived a little over a week ago, and ”Arizona” is what John Barton named this hybrid version of his "All Paul", inspired type Pool Cue Case.




My Arizona Pool Cue Case is either 2 Butts x 5 Shafts, or 3 Butts x 4 Shafts configuration, it has a Zippered Jump Butt Compartment, and also a Jump Butt Protective Sleeve for added protection incorporated in the Pool Cue Cases 18” Long Lower Pocket.

That Long Lower Pocket has John’s SUPER NEATO “L” Shaped Zipper for ease of access to the Long Lower Pocket, so you do not need a set of surgeon’s forceps to grab the items from the inside depths of the Long Lower Pocket with the “L” Shaped Zipper, as your hands will fit just fine with easy of access, and the Long Lower Pocket Pocket holds my 16” John Hager Extension with no problems.


The Arizona Pool Cue Case was ordered with John’s UltraPadTM Interior so each Cue Butt, & Cue Shaft Section fits snugly & safely like a baby wrapped in a receiving blanket. Giving each Cue Butt & Shaft Section great protection.


Up top there is an 8” Upper Pocket with a built in Chalk/Joint Protector Holder, that Upper Pocket also incorporates a Zippers running in a semi circle around the upper portion Pocket for easy access to the entire storage area. The Pool Cue Case’s Top Closure is a Barton Puzzle Latch magnetic type closure with no moving part to break on the Main/Top Cue access closure.




I did ask John to make the Pool Cue Case’s (2) POCKETS a extra 3/8” deeper than his normal depth of 1-1/4” deep pockets, and that extra depth worked out just great for storing a couple of “thick” items I carry, like my Pro-Just-A -Bridge creating no strain, or puffiness on the pockets.



The Pool Cue Case weighs in at a lean 6 Pounds, 2.0 Ounces including the detachable towel ring that weigh almost 1.5 Ounces by itself. No I have no weighted the Case full with 2 Butts x 4 Shafts, and the junk I seem to always put in my Pool Cue Case.


Last edited by CocoboloCowboy; 12-18-2011 at 07:29 AM.
  
Reply With Quote