Guys
After some discussion with Ssonerai in my ''Anniversary project'' thread, I've decided to start a new thread about bridge rack reproduction build. I'm not ready to start the project yet but I want to get as more information as possible while a wood bending expert is nice enough to share is knowledge.
I'll start with some random ideas to feed the discussion :
- First I will need the original rack dimension
- I'm thinking to use skateboard plywood kit similar to what is sold on that site
https://www.roarockit.ca/skateboard-building/street-deck-maple-7-layer-sets/#.XVNDeehKjcs
-I'll need to find the proper process for the intended shape (Ssonerai should help a lot about that)
Thank you for reading.
Every input is welcome
Thanks
Martin
After some discussion with Ssonerai in my ''Anniversary project'' thread, I've decided to start a new thread about bridge rack reproduction build. I'm not ready to start the project yet but I want to get as more information as possible while a wood bending expert is nice enough to share is knowledge.
I'll start with some random ideas to feed the discussion :
- First I will need the original rack dimension
- I'm thinking to use skateboard plywood kit similar to what is sold on that site
https://www.roarockit.ca/skateboard-building/street-deck-maple-7-layer-sets/#.XVNDeehKjcs
-I'll need to find the proper process for the intended shape (Ssonerai should help a lot about that)
Thank you for reading.
Every input is welcome
Thanks
Martin
Last edited: