I have a couple of old shafts that I don't use so I was wondering is it possible to convert from a 3/8x10 shaft to a 3/8x10 Modified? I have a butt with the modified pin I don't have a shaft for. The standard 3/8x10 will screw on but it's very tight and not a great fit.
If so, is it just a matter of re-tapping or is there more involved? Will a standard 3x10 tap work or is a special tap required? Thanks.
If so, is it just a matter of re-tapping or is there more involved? Will a standard 3x10 tap work or is a special tap required? Thanks.
