View Single Post
Old
  (#32)
JoeyInCali
AzB Silver Member

JoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond reputeJoeyInCali has a reputation beyond repute
 
JoeyInCali's Avatar
 
Status: Offline
Posts: 24,762
vCash: 4400
iTrader: 81 / 100%
Join Date: Jul 2004
Location: OC, California
   
09-17-2020, 01:44 PM

Quote:
Originally Posted by EL Picos View Post
You center the 2 ends in 4 independent jaws, because the concentricity of pin, barrel ... is unknow.
Or you can dial in the OD of the joint collar after the last pass and install the screw.
You don't center hole Uniloc QR screws.

And there is a trick to keeping that joint collar as smooth as possible after the last pass for easier indication .

Last edited by JoeyInCali; 09-17-2020 at 01:47 PM.
  
Reply With Quote