View Single Post
Old
  (#5)
Cocoa
AzB Silver Member

Cocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond reputeCocoa has a reputation beyond repute
 
Status: Offline
Posts: 72
vCash: 500
iTrader: 0 / 0%
Join Date: May 2015
   
01-11-2019, 08:08 AM

Quote:
Originally Posted by Dave38 View Post
Ok, any ideas as to how to clean this one? It's about 5 months old on a 314-3 shaft. I have tried: denatured alcohol with magic eraser, soft scrub, and toothpaste, using small brushes, and good cloths. It seems to be pitted, and the chalk dirt is in the pits. Customer wants me to make it white, then seal it as he doesn't like dirty ferrules. It is at 12.74mm, and he wants it to stay there, so sanding it down to smaller size is out.
Any help is appreciated.
Dave

Attachment 509613
Dave, what magnification is the picture you posted.

If you look closely similar porosity is in the black pad and also look at the grain of the maple?
  
Reply With Quote