Hey guys...I have a question. I'm sure there are different ways to apply the finish. But... When you apply the finish, do you do it before you drill, tap, and install pin? And before drilling and tapping shaft? Or after installing the pin etc.?
Hey guys...I have a question. I'm sure there are different ways to apply the finish. But... When you apply the finish, do you do it before you drill, tap, and install pin? And before drilling and tapping shaft? Or after installing the pin etc.?
What do you put, if anything, up against the collar when applying the epoxy or clear coat? Or nothing? I was thinking of a piece of delrin....Finish it after joint installed..
What do you put, if anything, up against the collar when applying the epoxy or clear coat? Or nothing? I was thinking of a piece of delrin....