Makita variable speed router, stuck on hi, anyone seen this before?

Good points above^^

Here’s some good info to add to it



https://s26462.pcdn.co/wp-content/u...chnical_Notes_on_Wood_Properties_and_U333.pdf


Sent from my iPhone using Tapatalk Pro

Thank You both for the response, It brought back a memory from years ago when I was taping a butt for the joint screw for a 3 8 10 and I was going in a little to fast and it burned the joint just a little so it must have hit that temp mark you spoke of, the 2 gents I was working under commented that I needed to slow down a little, Thanks Again for the info.