Can a shaft be tapped to accept both a modified 3/8 10 pin and a radial?
Thanks.
AJM
Thanks.
AJM
Mine has been tapped for over 2.5 years no issues at all very tight
The hole for radial should be .3125" before it's tapped.
The hole for modified 3/8 10 should be around .308".
If it's tapped for both, the 3/8 10 will be a little loose.
Mine has been tapped for over 2.5 years and is extremely tight not loose at all sometimes takes a second effort to break the cue down