Anybody have some inlay material that matches the Ivorine - 4 Rod?
Or at least very close to it ?
Thanks in advance,
Mike Gatzke
Or at least very close to it ?
Thanks in advance,
Mike Gatzke
inlay material
- Thread starter GatzkeCues
- Start date
Guess not
I guess not.
I guess not.
ivory
Yes Ivory is about the closest I have found also, but was hoping for
even a closer match.
Thanks for your reply,
Mike
Yes Ivory is about the closest I have found also, but was hoping for
even a closer match.
Thanks for your reply,
Mike
good idea
I have the rod and actually have thought of it.
I guess I was being a little paranoid about how brutal
that stuff is on tooling. I was also thinking of the
possibility of it wanting to pop the finish. I do know
that hss tooling does not like this stuff at all. Yes I do
use carbide.
I also have seen plenty of problems with the expansion
and contraction rates of other phenolics compared to
wood down here in the desert.
I already try to stay away from metal rings in my
cues as it is.
Thanks again for a response,
Mike
I have the rod and actually have thought of it.
I guess I was being a little paranoid about how brutal
that stuff is on tooling. I was also thinking of the
possibility of it wanting to pop the finish. I do know
that hss tooling does not like this stuff at all. Yes I do
use carbide.
I also have seen plenty of problems with the expansion
and contraction rates of other phenolics compared to
wood down here in the desert.
I already try to stay away from metal rings in my
cues as it is.
Thanks again for a response,
Mike
Ivorine 4
If you havent found a material that works yet say so and Ill pm you a link
Ivorine 4 is terrible to work with. I dulled a brand new carbide tipped $40 saw blade in one cut making a joint collar. Never again.
If you havent found a material that works yet say so and Ill pm you a link