Get rid of it and buy a real cue.
Get rid of it and buy a real cue.
Nice, maybe you should try growing up. If I wanted a smart ass answer I would’ve asked for it.
Then what are you doing here? Obviously they’ll let an idiot in Who has nothing better to do than troll peoples posts and make stupid comments. You must not know anything about cues and only came here to post a juvenile response.
You don't have enough posts to understand the forum you are on.
Pool players always give each other heat.
I gave you a little heat and you wilted and fell apart.
Oh well stick around awhile and you will understand.
I usually wouldn't respond to something like this but, maybe, just maybe, you have TOO MANY posts to understand that this is the "Ask a Cuemaker" section.. You know, for those who actually work on cues to respond. You know, those who can actually HELP the OP's. I think some good advice would be to save your harmless ball busting for other catagories. Just sayin'
I once left my Meucci inside my unlocked car.I've had enough fun here I'm out of this thread.
Lighten up guys this is pool not life or death.
Relax.
Don't take theses forums so seriously.
I was just having a little fun with the new person.
Oh bye the way I didn't know you were the forum cop.
I’m not above having some fun or joking around. But when like you said, Skins, when you are looking for a solution to a problem it’s a different thing. If you look back at the beginning he fired I fired back. He should’ve left it alone at that point.
Anyway I found my answer elsewhere. Simply took a long boot and Tightened a nut down against the insert and was able to work it out. Cleaned out the threads, little epoxy and we’re back shooting good as new! Thanks for the help!
Nice! Glad you were able to get it fixed.I’m not above having some fun or joking around. But when like you said, Skins, when you are looking for a solution to a problem it’s a different thing. If you look back at the beginning he fired I fired back. He should’ve left it alone at that point.
Anyway I found my answer elsewhere. Simply took a long boot and Tightened a nut down against the insert and was able to work it out. Cleaned out the threads, little epoxy and we’re back shooting good as new! Thanks for the help!
Do you have a lathe and did you face it off when the insert dried?