Early Predator sneaky

D

dragracer

Registered
I have a early Predator sneaky Model SPJLW.

I don't have the original shaft. Trying to figure out if there's a way to tell when it was made exactly. I have a line on shafts pre cat 314 & cat 314. Just would like to have the correct one.

I'm familiar with these cues. I bought new a 1st edition of this cue and the later one with uniloc joints back in the day. Both made by Falcon.

Just trying to couple it with a correct shaft.
Any help is appreciated
 
Celophanewrap

Celophanewrap

Call me Grace
Silver Member
I have a Predator that I bought in 94’ when they were still a very young company.
It’s a sneaky with a SS joint, 5/16 X 14 pin, green veneers and no wrap
I believe the very early Predators have a 5/16 x 14 joint and my cue on the shaft is just
314, no cat. About a year later I bought another Predator 1st edition, a little more ornate,
maroon with points and a wrap, still with a SS joint and a 5/16 X 14 pin and no cat on the
shaft, just a 314. I think that the cat came along on the shaft in about 96, but I may be
mistaken
I think if you have a 5/16 X 14 pin your original shaft would not have a cat, if you have
a uniloc pin then it would have a cat.
 
P

poolguy4u

AzB Silver Member
Silver Member
.




Does the line on your shafts go around the shaft near the collar?

Sounds like you have a couple factory 2nd shafts.



.
 
You must log in or register to reply here.
Top