i CHANGED THE TAPER ON MY MEZZ ProEx, it was 12.7mm and i went 11" back and started a conical taper down to 11.75! Hits even better! Less deflection and much better control of the CUE BALL! The ferrule came down real easy as well did not have to replace it!Does anyone know if trimming the shaft width on an ExPro is ok and what the minimum shaft diameter is before hurting performance if so?
Thanks,
Koop
i CHANGED THE TAPER ON MY MEZZ ProEx, it was 12.7mm and i went 11" back and started a conical taper down to 11.75! Hits even better! Less deflection and much better control of the CUE BALL! The ferrule came down real easy as well did not have to replace it!
I put a Zan Medium ON MINE!
I tried out a WX900 shaft for the first time last night, and was quite impressed. I had initially tried a WX700 with my Mezz MSP model and was disappointed with the amount of deflection compared to what I'm used to. Then I ordered and have been playing with a Mezz EXPro shaft for nearly 6 months, and have been very pleased with it, particuarly with the considerable less deflection.Just purchased a WX900 from the Mezz booth today at the SBE. Couldn`t be happier with this new shaft.
If you vheck out the awesome Mezz fans facebook page, you will find a nice writeup on WX Alpha :smile:Anyone has tried the new wx alpha shaft? Any thoughts and comparison with the others?
If you vheck out the awesome Mezz fans facebook page, you will find a nice writeup on WX Alpha :smile:
Here is a link to the same review for those not on Facebook
https://forums.azbilliards.com/showthread.php?t=477819
I might add that I have since purchased an ACE180 Mezz that came with the WX alpha shaft and I like it even more after taking the taper back a little and putting on a tip that I like. It is a great shaft, I like it a lot.
I just got a mezz axi. Two Months ago with wx900 12mm shaft. Been playing everyday with it. So I have an opinion on it.
I also just a few days ago picked up an Ex-pro shaft 12.5mm wavy and a Alpha hybrid 12.8mm with a 5-16 pin for jacoby joss schon
I wish I could find my calipers so I could measure the tapers every three inches on these three shafts I'm kinda curious. But anyways I'll be giving a review of the three soon. I will say mezz uses great shaft wood.