Looking for a highly credible table mechanic in NW area. (late model GCIV-so has the GCV frame)
I am 5 hrs from Portland OR, 5hrs from Spokane WA, 2hrs from Boise ID.
I am needing a re-cover, check and fine tune or try to improve any leveling issues and possibly new brunswick super speed rubber. (do not wish to turn my GC into a diamond)
Since they have to travel to me anyway and would likely involve staying over a night, could the rubber be done here (rather than send top rail off) since it would have time to dry overnight? Can they get perfect corner cuts, back cuts,etc.. on all angles out in the 'field' like that or would I have to send the top rail off.
Would really prefer to do it all here....IF.... it can be accomplished to perfection in the field?
Thank you for any input and names and contact info.
Will watch this thread now and then for input and will check my PM's from time to time also.
Thanks!
Obsespool
I am 5 hrs from Portland OR, 5hrs from Spokane WA, 2hrs from Boise ID.
I am needing a re-cover, check and fine tune or try to improve any leveling issues and possibly new brunswick super speed rubber. (do not wish to turn my GC into a diamond)
Since they have to travel to me anyway and would likely involve staying over a night, could the rubber be done here (rather than send top rail off) since it would have time to dry overnight? Can they get perfect corner cuts, back cuts,etc.. on all angles out in the 'field' like that or would I have to send the top rail off.
Would really prefer to do it all here....IF.... it can be accomplished to perfection in the field?
Thank you for any input and names and contact info.
Will watch this thread now and then for input and will check my PM's from time to time also.
Thanks!
Obsespool