Need Help - New case Spring Loaded , Joint Protectors won't fit
Hello ,
I just bought this new case , https://www.pooldawg.com/brand/outlaw/pool-cue-cases/outlaw-2-butt-2-shaft-horseshoe-hard-case
I got a sweet deal on it , I am a big fan of Joint Protectors as I have seen butts hit the floor pin 1st and do some damage. So I have used Jp's for years. This case is Spring loaded and it does not seem to have the extra room for the Joint Protectors sticking up. This is my 1st Spring Loaded Case , Do you guys who have them just not use Joint Protectors . I really like the look of the case , but feel un safe not using the Joint Protectors. The Butt goes in Pin 1st and shaft tip 1st. What is the general consensus. Or am I the only one who has ran into this. Sorry if this is in the wrong forum section. Thanks for any help or suggestions .
Hello ,
I just bought this new case , https://www.pooldawg.com/brand/outlaw/pool-cue-cases/outlaw-2-butt-2-shaft-horseshoe-hard-case
I got a sweet deal on it , I am a big fan of Joint Protectors as I have seen butts hit the floor pin 1st and do some damage. So I have used Jp's for years. This case is Spring loaded and it does not seem to have the extra room for the Joint Protectors sticking up. This is my 1st Spring Loaded Case , Do you guys who have them just not use Joint Protectors . I really like the look of the case , but feel un safe not using the Joint Protectors. The Butt goes in Pin 1st and shaft tip 1st. What is the general consensus. Or am I the only one who has ran into this. Sorry if this is in the wrong forum section. Thanks for any help or suggestions .
Last edited: