ralphdukephoto
New member
Hello!
I have an older Joss cue, ( lettering on the joint collars)
I want to change the weight of the cue, but, after removing the bumper, which is attached to the weight bolt with a small screw.
I noticed the hex shaped bolt is very close to the edges of the inside of the butt.
which means, I would need a very thin walled socket to remove it. this is something I do not have. Any suggestions???
Thanks
Ralph
I have an older Joss cue, ( lettering on the joint collars)
I want to change the weight of the cue, but, after removing the bumper, which is attached to the weight bolt with a small screw.
I noticed the hex shaped bolt is very close to the edges of the inside of the butt.
which means, I would need a very thin walled socket to remove it. this is something I do not have. Any suggestions???
Thanks
Ralph