18 pcs at around .598" ends. More than 1MM taper to the middle ( less than 2MM ). 29.25" look after you whack off the milled slot at the face for the Hightower spinning spur .
1 at .512" end and .860" face. Around 3.6 oz.
1 at .525 end. Will be a 4 oz shaft at 13MM.
You finish the two shafts and depending how much you charge, you pretty much pay for most of the cost of the 18 oversized ones.
$350 plus shipping.
PM me for questions .
First PM to say I want them gets them.
The labor I put on these plus 4 bits that needed sharpening is not even funny for what I'm getting for this lot.
If you are not happy with them, send them back. I'll refund the cost less Paypal fees and shipping costs .
These are better value than roll on the dice dowels you usually find out there that still need a lot of work and time to get them down to these sizes.
I have 500 dowels coming ( hopefully ).
And I like working with bins of shafts instead of 20 here and there.
Will not be selling any of those though as I'm splitting the pallet with other friends.
I might be posting near finished ones with ferrules installed already too.
If they don't sell at the regular FS section.
PM me questions if needed.
You'll get honest answers.
1 at .512" end and .860" face. Around 3.6 oz.
1 at .525 end. Will be a 4 oz shaft at 13MM.
You finish the two shafts and depending how much you charge, you pretty much pay for most of the cost of the 18 oversized ones.
$350 plus shipping.
PM me for questions .
First PM to say I want them gets them.
The labor I put on these plus 4 bits that needed sharpening is not even funny for what I'm getting for this lot.
If you are not happy with them, send them back. I'll refund the cost less Paypal fees and shipping costs .
These are better value than roll on the dice dowels you usually find out there that still need a lot of work and time to get them down to these sizes.
I have 500 dowels coming ( hopefully ).
And I like working with bins of shafts instead of 20 here and there.
Will not be selling any of those though as I'm splitting the pallet with other friends.
I might be posting near finished ones with ferrules installed already too.
If they don't sell at the regular FS section.
PM me questions if needed.
You'll get honest answers.
Attachments
Last edited: