Good Morning Guys..
Here is a different theme Crown Cap for a Collector's TAD Cue.
I thought I'd try the Re-spliced look, with the Clover on the tips.
The "tough" part was thinking how to do the re-splice without resplicing.
I came up with using Machined Ebony .040" wide Inlay Strips, Ebony Point, Ebony Bridge to do the Black Point/Veneer work.
Even TAD's Joint Rings are a "Project" by themselves.
How much would you charge to make just the Joint Ring? :grin-square:
A lot of work..
We all Know Dave Barenbrugge is "The Lord of the Rings"..
But Tad did make nice Ring Work in his time ..
Thank you for viewing..
Alton
"I write the music, but I do not write the Song" - Alton Takata
Here is a different theme Crown Cap for a Collector's TAD Cue.
I thought I'd try the Re-spliced look, with the Clover on the tips.
The "tough" part was thinking how to do the re-splice without resplicing.
I came up with using Machined Ebony .040" wide Inlay Strips, Ebony Point, Ebony Bridge to do the Black Point/Veneer work.
Even TAD's Joint Rings are a "Project" by themselves.
How much would you charge to make just the Joint Ring? :grin-square:
A lot of work..
We all Know Dave Barenbrugge is "The Lord of the Rings"..
But Tad did make nice Ring Work in his time ..
Thank you for viewing..
Alton
"I write the music, but I do not write the Song" - Alton Takata
Attachments
Last edited: