...
- Thread starter marek
- Start date
It should be possible.
I removed a sonic tip from a Mezz DI shaft with a cutter, just have to cut between ferrule and tip, it will come off for sure.
Without a lathe is almost impossible to put a new phenolic tip.
I removed a sonic tip from a Mezz DI shaft with a cutter, just have to cut between ferrule and tip, it will come off for sure.
Without a lathe is almost impossible to put a new phenolic tip.
No. Just no. Wrong.
Get a Tweeten Facing Tool. Then grind the phenolic tip flat
Then you can use a DP-190 epoxy and put whatever tip you want onto the BK3. Let the epoxy set for 2 days minimum and then shape the tip to whatever crown you want, quarter, nickle, dime and then go at it.
hope this helps,
,mike 'acedonkeyace' kennedy
ps. the Tweeten facing tool costs like $20.00.
Then you can use a DP-190 epoxy and put whatever tip you want onto the BK3. Let the epoxy set for 2 days minimum and then shape the tip to whatever crown you want, quarter, nickle, dime and then go at it.
hope this helps,
,mike 'acedonkeyace' kennedy
ps. the Tweeten facing tool costs like $20.00.
I'm a Samsara tip fan myself.