3/8" x 16 LONG Tap

Dave38

Dave38

theemperorhasnoclotheson
Silver Member
you will not find any off the shelf, but you can have them custom made, but you will pay $$$, not kidding.
DSave
 
Michael Webb

Michael Webb

AzB Silver Member
Silver Member
Boxcar said:
Where can I buy a 3/8" x 16 tap that can go in about 12"?

Thanks!

Boxcar
Click to expand...


If your tapping wood. You might consider using threaded rod and modify the front of it to a tap. Or take an 8 inch tap and weld an extension on it.
 
B

Boxcar

AzB Silver Member
Silver Member
Gentlemen,

Thank you very much for your replies. Special appreciation to Kim Bye!

Mission accomplished!

Best regards,
Boxcar
 
Michael Webb

Michael Webb

AzB Silver Member
Silver Member
Boxcar said:
Gentlemen,

Thank you very much for your replies. Special appreciation to Kim Bye!

Mission accomplished!

Best regards,
Boxcar
Click to expand...


It's not to often Kim misses a chance to make his post count go up, so I'm curious. What did you do?
 
B

Boxcar

AzB Silver Member
Silver Member
I availed myself to the camaraderie of My Brothers in Arms. Some came forward. Some remained discreet. I salute you, one and all.

Boxcar
 
Last edited:
Kim Bye

Kim Bye

AzB Silver Member
Silver Member
Mcues said:
Why did he need that length?

Mario
Click to expand...

I'm guessing he wanted to thread a buttsleeve for 3/8-16 weightbolts and that the 16" length was just a number he kinda threw out there. I gave him a link to the one I use, it's 8" long wich is plenty long enough for it's intended use and he seemed very happy with that :smile:
 
You must log in or register to reply here.
Top