CNC Suggestions

Bumlak · Oct 18, 2015

So I searched the forum as I always do and didn't find an existing thread that was specific to this question. I am looking at upgrading from Manual Pantograph (Gorton) to a CNC system for inlays. I have been browsing through some of 6040 4 axis machines and wanted to get some feedback on whether or not these machines are suitable for inlay on 2 piece cues and what, if any, modifications have to be made. Most seem to come with Mach 3 already and I've had some minor experience tinkering with that software.

Thanks in advance!
Erich Sternberg

cuebuyer4u · Oct 18, 2015

This one has the Z travel youll need its a good starter machine but not perfect.

http://www.ebay.com/itm/NEW-4-axis-...428335?hash=item28091a92ef:g:-ZAAAOSw~gRVtlTo

jkan101 · Oct 18, 2015

cnc

here is an option I use it do inlays etc... http://www.deepgroove1.com/cncmill.htm
You will have to add some type of headstock / tailstock option to hold the cue but it works, there are couple cuemakers who use this..

Joe

CNC Suggestions

Bumlak

AzB Silver Member

cuebuyer4u

Gamble Cues

jkan101

jkan101