Valley Rail Caps

joewag2

AzB Silver Member
Silver Member
How do you tighten the Valley rail caps?

I have a corner one that is really loose. I took out the top two small allen bolts on the pocket boot and pulled it back and couldn't see anything. I didn't want to pull out the staples on the bottom before asking.

It's a 7' Valley coin operated bar box that's about 6 years old.

Sincerely,

Joe
 

realkingcobra

Well-known member
Silver Member
How do you tighten the Valley rail caps?

I have a corner one that is really loose. I took out the top two small allen bolts on the pocket boot and pulled it back and couldn't see anything. I didn't want to pull out the staples on the bottom before asking.

It's a 7' Valley coin operated bar box that's about 6 years old.

Sincerely,

Joe

Basicly you have to remove the slate in order to get to the pocket casting mounting bolts located under the casting coming up from the bottom side, there's 2ea, 3/8" bolts and washers that bolt the casting to the top rails on each side, they help lock the body panels together as well.

Glen
 

joewag2

AzB Silver Member
Silver Member
Thanks Glen, not quite what I wanted to hear,...but while I'm doing that maybe I can figure a way to dampen the ball return system. If not I think I'm gonna need a bottle of asprin, or ear plugs. Man is that loud.

Thanks again!

Joe



Sent from my SCH-I400 using Tapatalk
 
Top