Larger Dead center

S

Ssonerai

AzB Silver Member
Silver Member
How will it be held (chucked)?
Can you just use a (blank/straight OD) taper sleeve to hold a regular MT shank center; and chuck the OD of the sleeve in a collet? Or is this for some other use?
 
youngstownkid

youngstownkid

AzB Silver Member
Silver Member
cueman said:
.What diameter and length do you want?
Click to expand...



I need a diameter definitely large enough to hold the largest center hole drilled by my largest center drill bit...#1 (or is #5 the largest?)...whatever that is...but as big as 5/8 or even 3/4 might even be better. Standard length.
 
ideologist

ideologist

I don't never exaggerate
Silver Member
youngstownkid said:
I need a diameter definitely large enough to hold the largest center hole drilled by my largest center drill bit...#1 (or is #5 the largest?)...whatever that is...but as big as 5/8 or even 3/4 might even be better. Standard length.
Click to expand...

If you still need one, PM me, I have a few
 
You must log in or register to reply here.
Top