Find an older Dufferin one piece cue ( one that has been sitting in a cue rack for at least the past 10 years) and is still relatively straight- just add a3/8 10 joint pin, phenolic insert in the shaft, a new tip and ferrule and clean up the shaft and you will have as good a sneaky as you can find that will not warp any more than where it is today. Mueller ( Troy Downey) can do the whole conversion for about $100. You will be very happy with the results! There was one for sale here on AZ for $149 and I would highly recommend it- just search bar cue under the for sale section- it may still be there!