I have had an idea for some time. I have always admired the quick - release joint that
Lucas I has used on their cues...I have thought that the design isn’t all that difficult, so why not re-create that in the 3/8 pin ?
A broken cue to provide the first prototype, followed by experiment on a pawnshop-special in case it fails.
The short piece was only finished until it worked. To determine that it WOULD work.
Better one is actually a result I feel quite proud of...
Lucas I has used on their cues...I have thought that the design isn’t all that difficult, so why not re-create that in the 3/8 pin ?
A broken cue to provide the first prototype, followed by experiment on a pawnshop-special in case it fails.
The short piece was only finished until it worked. To determine that it WOULD work.
Better one is actually a result I feel quite proud of...
