Cue late
- Thread starter showtimenga
- Start date
Not long enough , spindle bore not big enough , mill is fixed does not move . A big waist of money , not versital enough . Nuff said .
showtimenga
Registered
Ok thanks what i needed to know
showtimenga
Registered
Ya what i was thinking i went on and got it for 800 heck i can flip it and make money ..if nothen eles
The advertised spindle through hole is 1.5"- big enough for cuemaking. http://www.boltontools.net/11-x-28
Search the forums for a way to add a steady rest on the left and you can do quite a few operations on it.
Unfortunately, the bed is too short to taper full shafts & butts.
Search the forums for a way to add a steady rest on the left and you can do quite a few operations on it.
Unfortunately, the bed is too short to taper full shafts & butts.
showtimenga
Registered
Do u think a exstion be made for the bed i cant find one that they make.. heck i got it maybe able to swap it for somthing lol thanks guys..
Only limited by your imagination... and budget.
Maybe this Help
http://www.ebay.com/itm/EISEN-1236G...223700?hash=item35f71e4894:g:3-wAAOSwf-VWaMY~
EISEN 1236GH Bench Lathe with DRO & Stand, Made in Taiwan, Single-Phase 220V
I bought this lathe last year. For the price and how well this machinery was put together is more than what I need. For the price what you are about to pay for the one in your first post picture and comparing the price. I think you better off getting this Esien lathe. This Lathe is made in Taiwan, very good machinery and have very good electronic parts in this lathe.
http://www.ebay.com/itm/EISEN-1236G...223700?hash=item35f71e4894:g:3-wAAOSwf-VWaMY~
EISEN 1236GH Bench Lathe with DRO & Stand, Made in Taiwan, Single-Phase 220V
I bought this lathe last year. For the price and how well this machinery was put together is more than what I need. For the price what you are about to pay for the one in your first post picture and comparing the price. I think you better off getting this Esien lathe. This Lathe is made in Taiwan, very good machinery and have very good electronic parts in this lathe.
showtimenga
Registered
I only payed 800 for figure i could flip it if i cant use it
IMHO - making enough of a profit by 'flipping' it to be worth the time and effort
might be more of a challenge than you think.
Dale
