Hex Taper / Tolerance Info
I'm posting a diagram of the taper, done in 1" increments on a 12.5mm shaft.
I have since checked over all the shafts again and came across
a few of them that were too crooked to use.
They were anywhere from .030" - .100" out.
The rest of them were from 0 - .020", which I am considering good.
I hope this helps answer any questions.
Also, I apologize for the delayed response. We had an emergency
evacuation yesterday, due to a wildfire in our little town of about 1,100 people.
So it has been hectic. Personally, we suffered no damage, but a few buildings
and homes were damaged on the edge of town.
If there are anymore questions let me know and I will do my best to answer them.