FS: Westinghouse Ivorite Micarta stick

Buster8001

Did you say shrubberies?
Silver Member
Rating - 100%
38   0   0
Westinghouse Ivorite Micarta.
This stick will yield 4 one inch ferrules, and finish around 12.8mm. Better tooling may get the diameter closer to the 13mm mark.
$old shipped in the states. That's $old a ferrule - way cheaper than most charge. One guy I know through FB charges $150 a ferrule blank.

20191004_213750.jpg

20191004_213747.jpg

20191223_194740.jpg

20191223_194808.jpg
 
Last edited:

deanoc

AzB Silver Member
Silver Member
Rating - 100%
421   0   0
it sounds expensive because it is expensive,but
if you have everplayed with these as ferrules thenyou will know
how good they play and it could easily be worth your money

I have payed more ,but back then the initial cost was negligeable
compared to the benefits.

I would buy these if I were still out and amongst them.
 

Buster8001

Did you say shrubberies?
Silver Member
Rating - 100%
38   0   0
it sounds expensive because it is expensive,but
if you have everplayed with these as ferrules thenyou will know
how good they play and it could easily be worth your money

I have payed more ,but back then the initial cost was negligeable
compared to the benefits.

I would buy these if I were still out and amongst them.

Thank you, Dean.
 

timothysoong

TS Billiards
Gold Member
Silver Member
Rating - 100%
137   0   0
it sounds expensive because it is expensive,but
if you have everplayed with these as ferrules thenyou will know
how good they play and it could easily be worth your money

I have payed more ,but back then the initial cost was negligeable
compared to the benefits.

I would buy these if I were still out and amongst them.

Dean is right, I have purchased a lot of them at more cost. Unfortunately my shafts are at least 13-13.2mm, otherwise I would've snatch them as soon as the OP posted.

One of the best playing ferrule ever! These are no longer being made!
 

Buster8001

Did you say shrubberies?
Silver Member
Rating - 100%
38   0   0
Dean is right, I have purchased a lot of them at more cost. Unfortunately my shafts are at least 13-13.2mm, otherwise I would've snatch them as soon as the OP posted.

One of the best playing ferrule ever! These are no longer being made!

Thank you, Tim.
 
Top