Is there a chart for drilling different size holes for the different size pins? If not, could someone tell me the hole diameter for the most common pin sizes using self aligning inserts.
Being a Tool and Die maker for over 40 years isn't much help when dealing with wood. For indicating used cues, my experience is is very helpful. When cutting a piece of wood then measuring again the next day, it can be bigger or smaller. Since I got off topic, I took two broken house cues and made a ten on joint and glued the two pieces together, it took over a week before you couldn't feel where I glued it together. I'm sure using to different pieces of maple played a big part.
Anyway, someone want to be kind enough to give me info on the hole sizes for self aligning inserts would be Greatly Appreciated.
Being a Tool and Die maker for over 40 years isn't much help when dealing with wood. For indicating used cues, my experience is is very helpful. When cutting a piece of wood then measuring again the next day, it can be bigger or smaller. Since I got off topic, I took two broken house cues and made a ten on joint and glued the two pieces together, it took over a week before you couldn't feel where I glued it together. I'm sure using to different pieces of maple played a big part.
Anyway, someone want to be kind enough to give me info on the hole sizes for self aligning inserts would be Greatly Appreciated.