MontyPyFly
King of inconsistency
I have a table with no name plate. it's about 25 years old and I was going to put on new rubber when I recovered it. I assumed k66, oops
The curved face is a bit less than 7/8" (21mm)
The flat, glue end is a bit less than 1" (25mm)
That's even smaller than U-23, and close, but smaller than S-38 which I have never heard of.
Any input on profile and place to find it would be greatly appreciated. Thanks
Compared to K66
The curved face is a bit less than 7/8" (21mm)
The flat, glue end is a bit less than 1" (25mm)
That's even smaller than U-23, and close, but smaller than S-38 which I have never heard of.
Any input on profile and place to find it would be greatly appreciated. Thanks
Compared to K66
Last edited: