truing a 6 wing cutter

conetip

AzB Silver Member
Silver Member
When I made my cutters, I made them from bar stock and made the shaft 6.350 mm diameter. Then cut out the clearance etc and had them fitted with PCD inserts and edm ground concentric to the 1/4 inch shaft. So the mandrel is part of the cutter.
My wing cutters are in the picture album.
Neil
 

JoeyInCali

Maker of Joey Bautista Cues
Silver Member
When I made my cutters, I made them from bar stock and made the shaft 6.350 mm diameter. Then cut out the clearance etc and had them fitted with PCD inserts and edm ground concentric to the 1/4 inch shaft. So the mandrel is part of the cutter.
My wing cutters are in the picture album.
Neil

6.3 cm , you mean?

Ok, go ahead make me one.
1 7/8 diam and 3/32 kerf , 1/4 shank. :D
 

conetip

AzB Silver Member
Silver Member
I would if my contact was still working at the pcd grinding company. 1/4 inch is 6.350mm diameter. I can make up the blanks. Then you get them tipped and ground.
 
Top